Yamaha Rhino
CVT Filter Install
If you take your Rhino to the dunes, adding a filter
to the CVT (clutch vent tube) breather is a must. Without a CVT filter, your Rhino's
transmission can suck in sand and contaminate your clutches. Yamaha engineers
must think no one actually rides in the sand.
To install the CVT filter, remove the driver's seat. The cover
for the intake
tube is right there. Remove the four phillips screws on the front of the
cover and one
on the back (tilt the bed for easy access).
Take the cover off and slip the air filter over the tube.
The tube is oval so make sure your filter is snug, but not so tight that it
folds the tube.
Since this is a breather, it is not necessary to oil the
filter. And make sure you keep this filter clean so it can properly
cool your CVT!
Rhino UNI CVT Filter available at:
RhinoGiant.com
|
